Finer Gap Filling until Medial Axis is used. #1057
Closed
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
These gap filling settings almost completely fill even the finest gaps.
tested in printing and they work well.
my @widths = (1.5 * $w, $w, 0.5 * $w); # worth trying 0.2 too?
I know you said 1.5 is worth using, but I can not find a test case where it actually gets used. And why would it? anything 1.0 and larger gets filled with a single perimeter.
here is what I was using which works better
commit: f18f278
my @widths = (0.6 * $w, 0.3 * $w, 0.1 * $w); # worth trying 0.2 too?
And here are the settings that I find to be the best at not leaving little holes between sizes (though you could probably leave off the 0.004 as that ends up being more a "stitching" action than an actuall filling:
commit: 768d410
my @widths = (0.4 * $w, 0.04 * $w);